Back to Top BACK TO GALLERY |
The edge banding of 1.5" x 3" Black Walnut is attached with glue and 3" long screws set in counterbores. The counterbores are then plugged, in this case, with Red Oak for some interesting contrast. |
Back to Top BACK TO GALLERY |
This table is designed to attach to the wall on the far end. Somthing similar to a peninsula cabinet. The near end is equipped with 3 drawers on full extension roller bearing glides. The drawers are constructed of 1/2" thick Baltic Birch throughout, including the bottoms. They have an applied drawer face of Red Oak. |
Back to Top BACK TO GALLERY |
Each side of the cabinet is composed of raised panels set in frames constructed in the traditional "Rail and Stile" configuration. The material is 3/4" thick (+) Red Oak. |
Back to Top BACK TO GALLERY |
The material in this table base is 3/4" (+) thick Red Oak stained with Minwax, Special Walnut and then sealed with 3 coats of Deft full gloss lacquer. The top is made of the same Red Oak glued and screwed to a 5/8" thick substrate of plywood and then banded with 1.5" x 3" Black Walnut. The top was then stained like the base and then sealed with 6 coats of Varathane full gloss, water based polyurethane with an aluminum oxide additive for scratch resistance. This particular finish is actually sold for sealing floors. |